HYBCO FORM RELIEVING GRINDER w/OPTICAL COMPARATOR     ** CHOICE OF HYBCO MOTORIZED RELIEVING WORKHEAD,    FOR 5C COLLETS OR ERICKSON COLLETS **   ** "LISTA CABINET WITH HYBCO CAMS & ACCESSORIES **       MODEL:  1900/2100-SB   S/N:  TG-431    NEW:  1988                                                                  TABLE WORK SURFACE .................... 6" X 36"   LONGITUDINAL TABLE TRAVEL ............. 14"   CROSS TRAVEL .......................... 6-1/2"   GRINDING SPINDLE, VERTICAL TRAVEL ..... 7-1/4" HANDWHEELS, GRAD. ..................... 0.0005"   GRINDER SPINDLE TILT .................. 25° ABOVE & BELOW   GRINDER SPINDLE INDEXES ............... 360° GRINDING SPINDLE SPEEDS (2) ........... 3,800 & 6,400 RPM MAX. GRINDING WHEEL DIAMETER .......... 7" GRINDING SPINDLE TAPER ................ 3" PER 1 FT.   MODEL #2100 MOTORIZED  TWO-WAY RELIEVING FIXTURE: SPINDLE CENTER HEIGHT ................. 7- 1/2" APPROX. WEIGHT OF MOTORIZED FIXTURE ... 115 LBS.   OPTICAL COMPARATOR: SCREEN DIAMETER ....................... 10" POSITIONING COMPOUND TRAVELS,  CROSS ................................ 2"  LONGITUDINAL ......................... 2" MAGNIFICATION ......................... 20X                   APPROX. MACHINE WEIGHT ................ 2,000 LBS.                                                             MACHINE FEATURES:    FULL CAST IRON CONSTRUCTION TILTING WHEELHEAD SESIGN (+/- 25 DEGREES) ROLLER BEARING WAYS (LONGITUDINAL & CROSS) BALL SCREW FOR WHEELHEAD SLIDE GEAR BOX FOR LONGITUDINAL TRAVEL - FINE/COARSE SETTINGS   EQUIPPED WITH:                                         10" NIKON OPTICAL COMPARATOR ATTACHMENT W/LENS & VARIABLE LIGHT     INTENSITY CONTROL BOX   - GIVES THE OPERATOR A QUICK METHOD OF CHECKING TOOL     DIAMETERS, LENGTHS, ANGLES, AND RADII RIGHT AT THE     GRINDING WHEEL WITHOUT REMOVING THE TOOL FROM THE COLLET.     HYBOC ASSORTMENT OF CAMS, AND WHEEL HUBS, AS SHOWN IN THE PHOTOS "LISTA" TOOL CABINET FOR ACCESSORIES                HYBCO MODEL #2100-SB (S/N: RF-1757) TWO-WAY MOTORIZED RELIEVING  FIXTURE ON SWIVEL BASE "MINARIK" ELECTRONIC VARIABLE SPEED RHEOSTAT CONTROL                                                 HAND OPERATED COLLET CLOSER THIS WORKHEAD USES ERICKSON #500 COLLETS, LARGER CAPACITY  THAN A 5C COLLET TYPE   1.5 H.P./3/60/230-460 VOLT WHEELHEAD MOTOR                     MACHINE IS PRESENTLY WIRED FOR 220 VOLTS     SPECIAL NOTE: WE CAN PROVIDE A HYBCO No. 2100-SB FORM RELIEVING FIXTURE  WHICH USES 5C COLLETS  IN LIEU OF THE UNIT PRESENTLY ON  THE MACHINE, WHICH USES #500 ERICKSON COLLETS.  THERE IS NO CHARGE FOR THIS SWAP.     LINK TO VIDEO: https://youtu.be/jweqYmTLRMI                                                           ** INSPECT UNDER POWER IN OUR HARRISON, N.J. WAREHOUSE ** *** ORIGINAL PAINT; EXCELLENT CONDITION & APPEARANCE *** FOR MORE INFORMATION: Call Andy at 973-497-7600