滚齿机PFAUTER P-900
德国总览
将参数转换为英制
齿轮最大直径 | 900 mm |
最大模数或径节 | 16 |
配备
Machine has been delivered in 1974 without a Counter Steady.
This Machine was used for the production of larger worm gears ( Elevator industry)
and is equipped with a tangential head and a built-on table hydraulic workpiece clamping
device with various clamping tools for WP- Ø 400 / 500 / 600 mm.
However it is possible to cut regular spur gears also with helix teeth.
Program selection switch for various hobbing programs
· Automatic Adaptive Feed Control for the radial axis and the tangential axis (Adaptive Feed Control)
· Stepless adjustable of axial/tangential/radial feed rate
· Switch-over from roughing to finishing of radial feed with a template
· Hobbing Spindle drive by two speed motor, increased rpms, infinitely speed adjustment
· Automatic run-out hobbing device at the beginning and end of cutting
· Fine adjustment of hobbing tool, optical fine adjustment of hob slide and WP-slide
· Change gears in cabinet, 2 hob arbors, service tools, anti backlash compensation,
· Coolant facility with chip conveyor.
规格表
Max. gear-Æ without counter steady 900 mm
Module 10 mm
Hobbing length axial 450 mm
Table-Æ 700 mm
Table bore approx. 160 mm
Hobbing slide swivelling up to 240 °
Hob-Æ x length 190 x 300 mm
Hob shifting, tangential adjustment max. 200/300 mm
Hob spindle speeds infinitely variable 35 - 490 rpm
Feed ranges axial infinitely variable 0,14 - 9 mm/workpiece rotation
- " - radial infinitely variable. 0,035 2,24 mm/workpiece rotation
- " - tangential infinitely variable. 0,045- 23,2 mm/workpiece rotation
Spindle Drive / Total electrical 7/10 resp.16 kW - 380 V 50 cycles
Weight approx. 8.500 kg