Manufacture - Monarch-Stamco - new 1997 - upgraded 2008 Material - All common Aluminum alloys and clad products - Full hard to dead soft temper range Strip Width - 24 - 62" (entry) - 60 - 2" (exit) Strip Thickness - .0065 - .060" Entry Coil Size - ID - 16, 20, 24" - OD - 100" - Weight - 40,000 lbs - Unwinding = overwind only Exit Coil Size - Min cut = 2” - ID - 16, 20" - OD - 36" max for 2-3" wide cuts / 40" max for 3-6" wide cuts / 48" max for 6-12" wide cuts / 75" max above 12" wide cuts - Weight - 25,000 lbs max (each recoiler) - Winding: Over and under wind capable (in any combination) Slitter Capabilities - Arbor Size - 6.50" diameter - Maximum incoming width: 62” - Minimum incoming width: 24” - Maximum trim width: 60” - Minimum slit width: 2” - Cuts: .0065”-.030” (8 cuts maximum) / .031” - .060” (6 cuts maximum) - Maximum side trim width: none as trim can be wound to winder - Minimum side trim width: .50” Line Speeds - Low Gear – 500 fpm maximum - High Gear – 1000 fpm maximum Hand of Line - Right to Left Control System - GE 90-30 PLC Drives - Siemens Simoreg Line Description - Single Uncoiler - Dual Recoilers - Vertical Pass Slitting - Light/Medium Gauge aluminum Basic Line Equipment: - Unwind Reel Drive – 100 HP DC motor driven, dual speed gearbox - Unwind Edge Guide: North American - Unwind Pinch Roll - Entry Shear - (2) Stamco #6 Vertical Pass slitter heads (one in-line and one for next set-up; exchange heads with overhead crane) - Slitter Drive – 30 HP DC motor driven, single speed gearbox - Trim Pull Rolls: Pneumatically driven - Scrap Baller: 25 HP AC motor driven, single speed gearbox - Recoiler Drives – 100 HP DC motor driven, dual speed gearboxes Sold "as is, where is" EXW dismantled at plant, USA. Photos are a combination of when the line was installed and in it's current dismantled state. The line was properly dismantled by a rigging contractor!