X Y worktable (in) 160x80 Z axis stroke (in) 3.94 Maximum XY speed (ipm) 6141 Accuracy1: Position accuracy Pa 0.08 Average position range Ps 0.03 Fiber laser source W 4000 Cutting capacity (thicknesses)2 Steel (S185JR,S235JR, RAEX 250 C LASER) 24-3/4" Stainless steel (AISI 304, X5CrNi18-10 1.4301) 24-19/32" Aluminum (Al 99.5 EN AW 1050A) 24-19/32" Copper (Cu-ETP CW004A H040 EN1652) 24-5/16" Brass (CuZn37 CW508L H055 EN1652) 24-5/16" Consumption Maximum power consumption (kW)3 21 kW Average power consumption (kW)4 13 kW 1. Measure calculated following the norm VDI3441 on the maximum length of the axes. 2. The quality of cuts on limit thicknesses will depend on the geometries required, the quality of the material and the operating conditions of the system. At the limit values, the cut may have burrs on the lower edge. 3. Maximum consumption calculated on a system in a standard configuration cutting 3 reference sheets of mild steel between 1/32"-15/64" gage thickness. 4. Average consumption calculated on a system in a standard configuration cutting 3 reference sheets of mild steel between 1/32"-15/64" gage thickness. Recent PM have been completed See IPG official data below. IPG no longer offers 800w modules which were supplied with these units With new modules the machine is max 6000W but around 68% to get the 4KW rating of the machines The modules replaced in each laser and dates are listed below. They are all 1000W modules. PL1518976 Module 6 3/26/2021 Module 3 5/22/2020 Module 2 5/7/2020 Modules 3, 4, 5 9/23/2019 Module 1 10/27/2017 PL1518745 Modules 2, 4, 6 7/6/2020 Modules 1 , 3 5/19/2020